This brake backing plate gasket creates a reliable seal between the rear axle housing and the brake backing plate on classic Ford and Mercury vehicles (1949–1970). It prevents grease, dirt and moisture from entering the brake assembly…
New wheel cylinders are made to excat factory specifications. Please check application list closely and verify your bore size before ordering to insure correct parts. Applications list is as follows: 63/65 Falcon/ Comet conv,sedan,sw,sd…
New combi kits, or disc alignment hardware kits include all the springs, pins, shims and rings to properly rebuild your brakes. Complete kit, manufactured in the usa! Application is as follows: 73/ 79 Ranchero w/ 11 Brakes, 72 Torino…
Brand new semi-metallic brake pads are available to replace your tired originals. Please check application list carefully and insure your correct size before ordering. Applications are as follows: 57/ 59 hideaway top, 51a, sd, sw…
Oversize brake rod clevis pins that are (.340") diameter. If you're clevises and brake rods have some wear, its best to drill them out using an 11/32" drill bit to accept these oversize pins. Use this part number for ordering individual…
Used on both the emergency brake and the service brake camshafts in the rear backing plate. A-2331-A and A-2636-A ride in these bushings. Use this part number for ordering individual bushings. U.S.A.…
Inner goes between the backing plate and axle housing. Outer goes between backing plate and axle retaining plate. For cars with big rear wheel bearings. Uses 7/16" retaining bolts for backing plate. These are for high-performance…
Before you install new brake shoes, be sure to check the condition of the grease seals. It's good insurance to replace them now and save yourself the trouble later.
…