Add the final touch to your floor pan restoration with these oval shaped metal covers. Die stamped and galvenized like the originals, these come complete with 2 screws per cover and are sold each. 66/70 Falcon, 65 Comet
…
1980-214 This front door lower rear pillar, passenger's side fits:
1978-1979 Ford Bronco
1973-1979 Ford F-Series Pickup
Measurement 15x8x7
Weight 8lb
…
Replace that damaged or rusted rear frame rail section at the rear shackle with this new part. This part requires welding for installation
.overall length of 34 1/8"
…
Concourse correct shape not a generic replacement.
Zinc plated for rust prevention.
1965-67 plugs that are sold for 68-73
will work but are no where close to the originals.
1968 takes 4 per vehicle
1969-70 takes 2 per vehicle…
Replace that damaged or rusted rear frame rail section at the rear shackle with this new part. This part requires welding for installation.
overall length of 34 1/8"
…
Some sheet metal parts may require easily-accomplished cutting or modification to accomodate your particular vehicle. All sheet metal requires "fitting" for proper placing, and may require welding to accomplish installation…
Black powder coat will not rust like the aftermarket one with oxide
finish. Our plastic injected striker bushing will last longer than
extruded aftermarket bushings.
Exact reproduction of originals!
Also works as an…
Features:
• Complete Cab Pad Set
Set Includes:
(2) BAAA-5360 - Cab Arm to Frame Pads
(2) BAAA-5370 - Round Front of Cab Lower Pads
(2) BAAA-5371-S - Molded Arm to Cab Pads
(4) 7C-5387 - Cab Arm Bushing (For Original Arms…
Quality Replacement
Fits Left Or Right Side
Sold Each
New cab floor pan support U-channel for 1967-72 Ford trucks. Fits left or right side, sold each.
…
These small brackets are factory welded onto the cowl & are bolted to the fender & rear fender apron. If you are replacing the cowl they are a must have.
…
These small brackets are factory welded onto the cowl & are bolted to the fender & rear fender apron. If you are replacing the cowl they are a must have.
…
Patch panels are stamped from 19 to 20 gauge cold-rolled steel - unless noted otherwise. All sheet metal requires fitting for proper placing, and welding to accomplish installation. Painted or otherwise modified sheet metal is not…
All lower rear valances for 1967-70 have openings for backup lights.
Some sheet metal parts may require easily-accomplished cutting or modification to accomodate your particular vehicle. All sheet metal requires "fitting"…
A door skin is just the outside sheet metal, it attaches to the bottom and sides of your original door.
Some sheet metal parts may require easily-accomplished cutting or modification to accomodate your particular vehicle…