This slips into the little bracket under the gas tank inside the car. The choke rod goes through this grommet. A little bit of dish soap will make it slip in easier.…
For Model 97 carburetors
Special pin end locks choke open. Ideal for multi-carb setups. Lock the choke plates open with this clever detent plunger. Install into the airhorn as per the stock item, but press the pin end into…
For Model 97 carburetors. 1949-59 style for choke cable, includes seperate bracket that mounts on the carb body rear screw and clamps to the choke cable outer sleeve.
…
Cadmium plated control rods with the spring loaded ends. Ours are a bit more expensive than others, but they are made correctly and seat on the ball properly. 10-1/2" carb control rod. Runs from the throttle linkage that bolts to the back…
Three piece set needed to install the choke rod. The rubber grommet is for the bracket hanging from the fuel tank, leather washer, and steel cup washer. The leather washer goes against the outside of the firewall and the steel cup shaped…
Thermal Choke Line
Fits 1958-59 Ford Thunderbird With 332/352 V8
Durable Stainless Steel Construction
Also Available In Standard OEM Steel
Best Fitting/Highest Quality Reproduction Lines Available
Precison Bent Using…
In 26-27 the T's did not have a separate rod to choke the carb. This sleeve slips up the carb control beyond the cotter pin hole. A piece of wire goes from this sleeve down to the choke arm so when you pull up on the carb control, you…