Reproduction rocker panel for the 61-72 Ford F100 & F250 model trucks. This piece installs under the door. Each piece is stamped from heavy gauge steel and arrives EDP coated to protect against rust and corrosion.
Fits LH (driver) or RH (passenger) side. Sold individually.
The Rocker Panel is an important component of the body structure of your 1961-1972 Ford F100 or F250 truck. It is located on the lower portion of the vehicle's body between the front and rear wheel wells, running along the sides of the vehicle. The Rocker Panel serves as a protective barrier, helping to prevent damage to the body and providing structural integrity to the vehicle.
The Rocker Panel is available for both the driver's side (LH) and passenger's side (RH) of your Ford F100 or F250. It is typically made from high-quality steel or other durable materials to withstand the rigors of daily use and exposure to the elements.
Over time, the Rocker Panel may be subject to corrosion, rust, or damage due to road debris, moisture, or accidents. If the Rocker Panel becomes compromised, it is essential to replace it to maintain the structural integrity of your vehicle and protect against further damage.
When replacing the Rocker Panel, it is crucial to choose the correct side (LH or RH) that matches your specific vehicle. This ensures a proper fit and alignment with the rest of the body panels. It is recommended to consult with a trusted automotive professional or refer to the manufacturer's instructions for the precise installation process.
By replacing the Rocker Panel, you can restore the structural integrity of your Ford F100 or F250 truck and maintain its overall appearance. It is an essential component for preserving the body's integrity and protecting against potential damage.
Auto Metal Direct is a team of true car guys with years of experience in sheet metal reproduction, car restoration and paint/body work. We believe that quality is not subjective! Our mission is to provide the best customer experience for the Ford, Mopar and GM classic car markets - both in products and in service.
Our panels are made from proper gauge steel and include all correct-as-original clips, tabs, flanges, bends and seams. Each time a prototype body panel comes off of a new tooling, we test fit it on a car. The marked up prototype is then used to change and improve the tools, and a new prototype is produced. This procedure might be repeated multiple times but, once the part is finally approved, you can be assured of a quality part.
| Make | Model | Years |
| Ford | F-100 | 1961 - 1972 |
| Ford | F-250 | 1961 - 1972 |
| Brand | AMD |
| Gauge of Metal | 21 Ga |
| Height | 9 in |
| Length | 37.5 in |
| Weight | 36 lbs |
| Width | 5 in |
